PVC plastic Versatility
Time：2013/10/07 10:30:39 Hits：1304
pvc glue is building, electrical conduit , agricultural irrigation, industrial sewage and other projects using PVC pipe fittings bonding. PVC glue products are new, fully transparent solution component adhesive , designed for lifting difficult to stick to a transparent or white PVC plastic products, research and development of special glue transparent PVC plastic products , can be used in the plastics and plastic , plastic and metal, plastic and non- stick or cross intermetallic bonding problems .
PVC glue has the following characteristics :
1 , having a room temperature curing , easy operation, high bonding strength, fast positioning, high elasticity, soft film , curing non-toxic , and many other advantages .
2, has excellent resistance to water , heat, acid , alkali , corrosion resistance, oil resistance and non-whitening and other excellent features .
Applications: General purpose, low viscosity, for bonding PVC, bonding between metal and other materials . Versatile, can be used in PVC, PE, PP, ABS, PS, PMMA, nylon , sponge , film, metal , non-metallic materials such as interoperability and cross- stick adhesive .
PVC glue technical performance :
1, Appearance: transparent viscous liquid
2 , the viscosity ( at room temperature 25 ℃): 5 × 10-5 × 10mpa.s
3, the peel strength : N / cm canvas / canvas > 40 ;
4 , shear : PVC / PVC> 40; PE film / PE film > 8 ; rubber > 25 ; Metal / sponge , foam, torn.
5 , after immersion in water : strength almost unchanged : Solid content 40-50%
PVC glue to use:
1 , with a dry cotton cloth or sandpaper will next face of dust, oil, rust removal , then acetone or trichlorethylene detergent to clean the surface then .
2 , if the bottle of glue glue first with cotton cloth to wipe clean, then put the needle or PE dropper can be used after the glue to control traffic , ensure that the use of the results.
3 , after being followed by a small drop of surface adhesive, for bonding instantly and keep up to hardening , hardening time ranging from a few seconds to several minutes . For about 30 minutes to reach the practical strength , the highest intensity is obtained after 24 hours .
4 , after use clean bottle and tighten the lid and store in a cool dry place.
PVC glue Note:
1 , do not wear knit gloves , HR series cyanoacrylate is woven glove material will be rapidly absorbed polymerization reaction to produce high heat , it will burn your hands, so please do remember , do not wear knit gloves .
2 , if not careful eye contact , because after curing glue hard will hurt the eye , do not rub their hands and rinse immediately with plenty of water or warm towel to make eyelids sweating naturally separated , and not forcibly pull seriously, and hospital emergency treatment ; skin contact with warm soapy water , acetone , HR series solution glue removal .
3, HR series with cyanoacrylate volatile irritating when used in a large number of workplaces should be ventilated .
4, when there is a large leak can be cured with water and then scrape .
